Taylor Saw Mill

Taylor Mill near Londonderry in Derry NH, working vertical saw from 1810 run by waterThe Ballard State Forest in Derry is 71 Acres surrounding a pond, with picnic tables and walking trails, but the main attraction is the Taylor Sawmill. Built 200 years ago, around 1799, it was an advance in technology from a pit saw, where two men used a long two handled saw, one standing above the timber and the other in a dug pit below. The “Up and Down Sawmill” is a mechanized version of the pit saw, using a water powered system of gears and shafts to drive the long blade of the saw. Generally only the saw blade was powered and logs were pushed through by hand, but with some ingenuity the moveable carriage was developed, to move the log through the moving blade.

For a technical explanation of how the Taylor Sawmill works see click this thumbnail for a spectacular explanation!

Tallor Sawmill a technical explanation, click thumbnail for a modelOne of the beautiful results of this type of sawed lumber is that the wood doesn’t display the typical curved cut marks seen on lumber cut by circular saws. Preservationists and renovators prize finding original timbers in old colonial era homes that display the marks of pit saws or “Up and Dow” sawmills. Cut marks are even used for dating colonial homes. This type of lumber, known as “sash sawn” lumber, is produced at the Taylor Saw Mill on the second and fourth Saturdays of every month during the spring and summers. Demonstrations run generally from about 10AM to 3PM through the end of September, as long as there is sufficient water to run the waterwheel at the dam. (This shouldn’t be a problem in 2009!)

The “Up and Down Sawmill” was a short lived technology, which was replaced by the water powered circular saw by about 1825. Circular sawn logs, driven by water turbines, steam, electricity and computers are still the most common type of lumber produced today. Being a short lived technology, there are only a few examples of this type of “Up and Down Saw” surviving in the United States. Other than Derry, you can see one at Old Sturbridge Village, in Massachusetts, or at the Shelburne Museum in Vermont.

Taylor Mill Runing under water wheel power in Derry NH, note the blade and yoke in a blur

The Taylor Saw Mill is located on Island Pond Road in Derry, New Hampshire, on the left, about 3.7 miles from Clam Haven. The historic site is run by both the New Hampshire Division of Parks and Recreation and the Division of Forests and Lands Community Forestry and Stewardship Bureau. For more information call the Urban Forestry Center at 603-431-6774 or see the Division of Forests and Lands website on the 200 year old Taylor Up and Down Sawmill.

Browse the Google map for detailed directions.